HVAC Repair in Mayville, ND
Homes here need heat from September through May and cooling from June through August. If your system quits, tell us what it's doing and a licensed contractor who covers Traill County will get in touch.
Tell us about the job
It takes about a minute.
Nine months of heat, three of cooling, nights near 3 below zero
Your furnace is the machine doing the real work in Mayville. It runs September through May, and on the nights that average 3°F it doesn't get much rest between cycles. Every start is a small strain on the igniter and the parts that sense the flame, and after enough winters one of them quits. That's the furnace that won't fire on the coldest morning of the year.
Summer asks less of the house, just June through August, with afternoons around 79°F. That's still enough for a low refrigerant charge or a weak capacitor to leave the air conditioner blowing warm air instead of cold. Traill County has seen 67 winter storms and 70 damaging wind events over the past ten years, and across North Dakota, 7% of households lost power for a full day or more in 2024. Most furnaces and air conditioners come back on by themselves once power returns. If yours doesn't, that's worth a call.
- 9 months
- September through May, your system heats
- 3 months
- June through August, it cools
- 3°F
- the average winter night it heats against
- 79°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
North Dakota requires HVAC contractors to hold a state license.
The license is held by the contractor, not issued per job. The Secretary of State keeps that record, and it is the record a homeowner in Traill County can check a contractor against.
For a repair on a heating and cooling system, this license is what stands behind the work. There is one exception worth knowing. In North Dakota, work under $4,000 does not need a licensed contractor at all.
Sources: North Dakota Legislative Branch · North Dakota Secretary of State
- Why is my heat not working?
- The most common cause is the igniter or flame sensor failing, which stops the furnace from lighting even though the blower still runs. A dirty flame sensor will read as no flame and shut the burners down as a safety measure. It can also be a closed gas valve, a tripped breaker, or a thermostat set wrong or with dead batteries. With winter nights here averaging 3°F, a furnace that won't fire needs attention fast, so check the thermostat and breaker before anything else.
- Why is my system running but not cooling the house?
- If the blower is running but the air coming out isn't cold, the most likely cause is low refrigerant from a leak, or a coil that's frozen over from restricted airflow. A dirty filter can choke off airflow enough to freeze the coil, so check that first. If the filter is clean and the air still isn't cold, the system needs a contractor to check the refrigerant charge and the coil.
- What can I check before calling for HVAC repair?
- Check the filter first. A clogged filter restricts airflow and can cause both weak heating and weak cooling. Check that the thermostat is set to heat or cool as needed and has working batteries, and check the breaker or fuse for the system hasn't tripped. If the outdoor unit is covered in snow or debris, clear it, since blocked airflow outside affects performance inside. If those checks don't fix it, a licensed contractor will need to diagnose the rest and price the job for your house.