HVAC Repair in Velva, ND
Homes here need heat from September through May and cooling from July through August. If your system quits, tell us what it's doing and a licensed contractor who covers McHenry County will get in touch.
Tell us about the job
It takes about a minute.
Nine months of heat, and nights that test every part
Your furnace in Velva runs from September through May. On winter nights that average 3°F, it holds long burner cycles to keep up, and the igniter and ignition control take the wear from that. When one of them gives out, the furnace won't fire, and on a night that cold you feel it fast.
Summer asks less of the system here, just July and August, with afternoons averaging 79°F. An air conditioner that has sat idle most of the year can show a weak capacitor or contactor the first time it has to run hard. McHenry County has also logged 30 winter storms and 41 damaging wind events over the past ten years. If the power drops and your furnace doesn't restart on its own once it's back, that's worth a call.
- 9 months
- September through May, your system heats
- 2 months
- July through August, it cools
- 3°F
- the average winter night it heats against
- 79°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
North Dakota requires HVAC contractors to hold a state license.
The license is held by the contractor, not issued per job. It is the business that is on record with the state, not any single repair. That record means North Dakota has checked this contractor before, and continues to hold their license against their name.
There is a carve-out worth knowing about. In North Dakota, work under $4,000 does not need a licensed contractor. A heating and cooling repair can land on either side of that line depending on what the job turns out to need, so the license may or may not apply to the work being done at your house.
Sources: North Dakota Legislative Branch · North Dakota Secretary of State
- Why is my heat not working?
- The most common reason is the igniter has failed or the flame sensor is dirty, both of which stop the furnace from lighting even though it's still running. A tripped breaker or a thermostat set wrong or dead on batteries causes plenty of no-heat calls too. Check that the thermostat is set to heat and has power, and check your breaker panel before assuming the furnace itself is broken. With winter nights here dropping to 3°F, a furnace that won't light needs a contractor out the same day.
- Why is my system running but not cooling the house?
- If the blower is running but the air isn't cold, the system is likely low on refrigerant or the outdoor unit's coil is dirty or iced over. A clogged filter can also choke off airflow enough that the house never catches up, especially on a 79°F afternoon. Check the filter first since that's the one thing worth trying yourself. If the filter is clean and the air still isn't cold, the problem is inside the system and needs a contractor to diagnose.
- What can I check before calling for HVAC repair?
- Check the thermostat first, since a wrong setting or dead batteries look exactly like a broken system. Check your breaker panel for a tripped switch, and check the filter to see if it's clogged enough to block airflow. If the furnace has a standing pilot, check whether it's still lit. If all of that looks normal and the system still isn't heating or cooling, the issue is inside the equipment, and a licensed contractor will need to diagnose it and price the repair for your house.